A comprehensive resource for safe and responsible laser use
If your camera is hit by a laser beam
The following information has been provided by the International Laser Display Association (ILDA). It is primarily about camera sensor damage at concerts, but also applies to using laser pointers “around the house” and aiming them into a camera.
Lasers emit concentrated beams of light, which can heat up sensitive surfaces (like the eye's retina) and cause damage. Camera sensors are, in general, more susceptible to damage than the human eye.
For large scale shows such as televised concerts, laser show producers work with clients to avoid TV camera locations and video projectors (ILDA Members, see this page for details; login required). However, it is not possible for laser show producers to be responsible for all cameras and camcorders which might be used at a show.
Tips for audience members with cameras when lasers are in use
Therefore, if you attend a show as an audience member, you should take reasonable precautions not to let a laser beam DIRECTLY enter your camera lens.
- You can photograph the beams in midair, or doing graphics on a screen. If you can't see the laser source (projector output aperture or bounce mirror) in your viewfinder, this means you're not getting the full beam power into your lens. Indirect viewing like this should not cause damage.
- Avoid beams which are coming straight into your lens (or bounced off a mirror or other reflective surface and then into your lens). The damage potential is much greater when the entire beam power enters the camera lens.
Eye safety is first
The primary safety concern for laserists is that the show is eye-safe. A good working definition of "eye-safe" is that everyone leaves the show with the same vision they entered -- there is no detrimental change to a person's vision. International safety standards such as IEC 60825 and ANSI Z136 set "Maximum Permissible Exposure" levels for laser light. Shows done at or below the MPE should cause no problem for human eyes. Even shows which exceed the MPE have remarkably safe records (eight documented or claimed eye injuries out of 109,000,000 persons viewing continuous-wave laser shows over 30 years).
However, there are no MPEs for sensors such as CMOS or CCD chips. This means a show may be perfectly safe for eyes, but could possibly damage a camera sensor. One reason is that camera lenses may gather more laser light, and concentrate it to a finer point. Another reason is that CMOS or CCD sensors are more easily damaged than the eye.
Due to the many varying factors involved with lenses and sensors, laser show producers cannot be responsible for audience-member damage to cameras or camcorders.
Type of damage
The degree of damage can vary widely.
- We have seen cases of minor damage, such as small areas of a few pixels which no longer work. The pixels are not noticeable unless in an area of uniform color such as a blue sky.
- In more extreme cases, there may be larger or more extensive dead-pixel areas. Or there may be "burn in" of a laser image. The damage is readily noticeable in most photos or videos. In this case, the camera is ruined for quality use. The image below shows numerous laser-caused spots on an HP Photosmart 945, a 5-megapixel camera. Click on the image to see the full-size (100%) original photograph. (Photo courtesy Aljaž Ogrin.)
- Damage to one spot may result in a horizontal or vertical line. In this case, data from the entire row or column of sensors can no longer be read out properly.
Search YouTube and other internet sources for videos and pictures of laser-caused damage. See for example Laser light kills Canon 5D Mark II, or Concert lasers destroy RED EPIC image sensor.
Note that not all claims of laser damage are valid. In March 2009, we reviewed a case where it was claimed that a Fuji F60fd 12-megapixel point-and-shoot camera was severely damaged by a laser. ILDA analyzed video from the camera, and determined the probable cause to be a very bright white light. Also, this YouTube video shows a standard camera flash (speedlight) causing severe damage to a CCD sensor in an instant.
More information on laser eye safety
ILDA has presented information about audience-scanning laser shows in the scientific paper "Scanning Audiences at Laser Shows: Theory, Practice and a Proposal". This gives some reasons why even shows which are well above the MPE have not caused any apparent eye changes in millions of audience members. Some of the reasons may also be relevant to why some camera sensors are damaged while many others are not.
More information for ILDA Members
ILDA Members can get more specific information on avoiding camera and video projector damage, on this page (login required).
In September 2014, a leaked copy of Apple’s guide to iPhone damage, furnished to its authorized repair centers, listed “Damage due to laser contact with camera” as an Out-of-Warranty Service item. See this LaserPointerSafety.com news story for more information.